A Guide to Fixing of the Deadbolt on Your Door

Deadbolts are far much effective in securing your home from intruders than spring-loaded door knob. The deadbolt opening from any side can only be done with a key. If you have the objective of installing a deadbolt to your home; it is quite easy. Most of the manufacturers have a template instruction you on how to install it. To get a clear picture of installing a deadbolt, read this article.

Start by reading on the manufacturer’s instructions template. It has reference indicating points to marked on the door using an awl. This position should not be less than six inches above the door knob

The next thing is to drill a hole for the deadbolt. The holes are to be made to the points marked according to the manufacturer’s template. The holes should be made using a hole saw.Finishing the hole from the other side of the door will prevent splinters. You can use a standard bit to drill the hole in case you hole saw isn’t deep enough to penetrate the breadth of the door.
Where To Start with Doors and More

The third step involves drilling a hole through the edge of the door. Make use of the 11/2″ spade bit drill. Go on to mortise the area around the faceplate. A wood chisel should be used so that it will be flush with the door. The rounded corners will call for a smaller chisel.
The 10 Laws of Deadbolts And How Learn More

The next step involves securing the bolt to the door. You have to continue mortising until the faceplate fits perfectly. Use screws to fasten the deadbolt to the door.

The nest stage is the installation of the cylinder and the thumb level. Start of fixing the exterior side and ensure that the writing is upright. Then move on the interior and tighten the screws with the mounting holes inside the lock. Use the screws to fasten the deadbolt.

Use lipstick or paint to mark the end of the bolt. Shut the door and by severally turning the bolt, maker the door frame. Use a 7/8″ spade bit to make two holes overlapping the door frame for the deadbolt. Mortise the surrounding of the holes such that the strike bolt will be flush with the door frame. Drill pilot holes and fasten the bolt with screws.

This done, your home will be under higher security than it would be on a standard spring loaded door knob.In case you feel that the procedure is somehow complex for you, you beer seek an expert to do it for you. This will help you avoid costly mistakes which you can do on your own. Such a mistake can mean that you deface your door with ugly marks which you won’t likeKeeping an eye on the manufacturer’s template and the guide to help you get it right.